Place one end of blank into the channel with the stamped side facing up. First, take your bracelet and place it in the holding slot of the bending bar tool, then bend it over the curve until it is completely around it. Using the palm of your hand, bend the bracelet half way around the bar.
Then Rotate The Bracelet Until It Sits On Top Of Your Wrist.
Do not stretch the cuff to fit over the top of your wrist. I made this block the same dimensions as a few you can find on amazon. This metal bending tool was developed by impressart, the leader in jewelry stamping tools and.
Use The Guide Marks To Evenly Space Out Letters And Align Stamp Impressions.
Bracelet / metal shaping block with 5 nylon shapers tdsonlinestore 5 out of 5 stars (23,972) $ 43.24 free shipping add to favorites steel bench block hammer stamp jewelry 4 x 4 x 3/4 jewelry making work surface hardened. Trace an existing bracelet to get a good size. The bracelet will lose it shape and create a stress point in the metal, causing the cuff to break.
Place Bracelet Blank Horizontally On Stamping Block.
Aluminum, brass, copper, alkeme, thin steel and more. Coil wire onto one side, add beads, and coil around the other side. In this case it is just an oval shaped piece of wood.
Bracelet / Metal Shaping Block With 5 Nylon Shapers Tdsonlinestore 5 Out Of 5 Stars (25,423) $ 43.24 Free Shipping Add To Favorites Bench Anvil Multi Tool Kit (Anvil, Round Bracelet And Ring Mandrels, Pin) #2.
Firmly place your thumb against the end of the bracelet to secure it in place. Secure bracelet stamp guide in the center of the bracelet blank. To put on the bracelet, turn the cuff sideways and slide it onto the side of your wrist.
